Do you coordinate CAT6 Installation with general contractors and property managers in San Bruno?+
Yes. Almost every San Bruno project we run is coordinated with a GC, architect, MEP engineer, or building management team. Our PMs attend OAC meetings, submit shop drawings and rack elevations, coordinate ceiling access windows with other trades, and honor building rules for freight elevator use, badge access, and after-hours work.
How long does a typical CAT6 Installation project take in San Bruno?+
Timelines depend on drop count, pathway complexity, and after-hours restrictions. A small San Bruno tenant improvement of 20–40 drops usually completes in 2–5 working days. Larger San Mateo County projects with backbone fiber, MDF/IDF buildouts, and multiple floors typically run 2–6 weeks. We publish a per-phase schedule with the quote so your GC and IT team can coordinate cutover.
Can existing cable be reused during a CAT6 Installation refresh in San Bruno?+
Sometimes. On San Bruno refresh projects we Fluke-test the existing plant first: if runs pass CAT6 or CAT6A channel spec and pathways are clean, they stay. Anything failing certification, abandoned per NEC 800.25, or unlabeled gets removed and replaced. You get a channel-by-channel keep/replace decision — not a blanket rip-and-replace bill.
Is CAT6 Installation in San Bruno a permitted trade under the county?+
Low-voltage installation in San Bruno falls under California C-7 and C-10 contractor scope and, depending on scope, may require San Mateo County building or electrical permits — especially for conduit rough-in, penetrations, and rated-wall firestopping. Access Cabling pulls permits when required and handles inspections directly with the AHJ.
Do you handle the rack, patch panels, and switch cabling too?+
Yes. Standard scope includes wall-mount or floor-standing rack (Middle Atlantic, CPI, or APC), patch panels, horizontal cable management, ground bar, UPS mounting, and pre-terminated patch cords from panel to your switch. We coordinate switch install with your IT team or vendor.
Can you replace old CAT5 or CAT5e cabling?+
Yes, and it's one of our most common projects. We can overlay new CAT6 alongside existing runs and cut users over one at a time, or remove and replace in-place when abandoned cable removal is required by code (NEC 800.25). Old cable removal is often a code requirement in California jurisdictions during renovation.
Does Access Cabling handle prevailing wage projects or public works in San Bruno?+
Yes, Access Cabling is fully equipped and experienced to handle prevailing wage and public works projects within San Bruno and San Mateo County. As a licensed C-10/C-7 low-voltage contractor, we understand and comply with all state and local regulations for such projects, including certified payroll and specific project requirements. We have a proven track record of successfully executing sensitive and compliance-heavy installations for public sector entities and government-funded initiatives.
